|
|
Safety
Make sure that the machine speed and the type
of material are within the specifications on the tool itself. Make
sure that the disk is undamaged before fitting. If there is any reason
to believe that the disk is damaged or has suffered an impact DO NOT
USE IT; contact the manufacturer.
Do not use cutting disks for planing, grinding, bevelling or any machining
operation other than cutting.
Fit the disk with the arrow pointing in the direction of rotation
of the machine.
Make sure that the machine's shaft is undamaged and unworn and that
the tool mounts without play.
Make sure that the disk mounting flanges are of the same diameter,
completely flat, clean and tightened down as specified by the manufacturer
of the machine.
If the disk is used for cutting hard, non-abrasive material for an
extended period of time, it may lose its cutting edge. To redress
it, run a few cutting cycles on a soft abrasive material or on the
block supplied on request.
|
|
